Auto Fleet Management

Email Us

info@dms-ksa.com

Eurosens DPS sensor converts air pressure in the air suspension line to the output voltage or digital messages via serial RS485 or automotive CAN bus J1939 protocol. A thin-film bridge is used as the pressure transducer.

Advantages

Eurosens DPS A is a basic model of Eurosens axle load sensor with 0-5 V analog output.

Eurosens DPS RS and DPS CAN have smart CPU and extra features:

Eurosens DPS CAN

Eurosens DPS A

Eurosens DPS 485

Specifications

  • Eurosens DPS A/485/CAN
  • Eurosens DPS A output
Supply voltage, V:10 – 60
Reverse polarity protection:Yes
Temperature range,°C:-40 – +85
Output interfaces:0-5 V, RS-485, or CAN
Output data protocol:LLS, CAN SAE J1939
Seal rating:IP 67
Pressure, MpaOutput voltage, V
00,25
0,10,70
0,21,20
0,31,55
0,42,00
0,52,50
0,62,95
0,73,30
0,83,80

Eurosens DPS 485 uses LLS/MODBUS protocol. Eurosens DPS CAN uses CAN bus J1939 protocol with configurable PGN. After Eurosens DPS installation and wiring are done, calibration should be performed in which you are mapping the output signal to the load on the vehicle suspension.